Uses For 4 Way Speaker Cable Selector Switch
This switch allows four pairs of speakers to be run from an amplifier with only one set of outputs, or four pairs of speakers from the one speaker cable. The switch allows you to listen to one pair, two pairs, three pairs, or all four pairs at once! The spring clip terminals accept speaker cable up to 16 AWG.
Impedance: Prevent Damage to your Amp!
Please note that this switch can only be used with an amplifier that can operate down to 4 Ohms. If you are not sure if your amp is compatible, get in touch with us.
Impedance switching built into the unit ensures the minimum impedance seen by the amp is 4 Ohm (if using 8 Ohm speakers), no matter how many of the pairs of speakers are switched on. See chart below.
Impedance Chart
Switches on (impedance):
- 1/2/3/4 (8 Ohm)
- 1+2 (16 Ohm)
- 1+3 (4 Ohm)
- 1+4 (4 Ohm)
- 2+3 (4 Ohm)
- 2+4 (4 Ohm)
- 3+4 (16 Ohm)
- 1+2+3 (5.3 Ohm)
- 1+2+4 (5.3 Ohm)
- 1+3+4 (5.3 Ohm)
- 2+3+4 (5.3 Ohm)
- 1+2+3+4 (8 Ohm)
Model Number | 126234 |
---|---|
RRP | 38.00 |
Specs | - Power Handling: 100w max per channel
- Terminal Type: Standard push speaker terminals - Width: 177mm - Height: 48mm - Depth: 107mm |
4-Zone 8-Speaker Pack with 6.5-Inch In-Ceiling Speakers Poly Cone DBUN900029
As low as $301.58 Was $434
RRP $382